BA DT08 SL EN – Edition 1.0 * dt08b210.fm
2-9
Safety instructions
2.8
Warning of special hazards
Electrical energy
• Use only original fuses with the specified current rating!
Switch off the machine immediately and rectify the malfunction if trouble occurs in the
electrical system!
• When working with the machine, maintain a safe distance from overhead electric lines!
If work must be carried out close to overhead lines, the equipment/attachments must be
kept well away from them. Caution, danger! Get informed on the prescribed safety
distances!
• If your machine comes into contact with a live wire
• Warn others against approaching and touching the machine
• Have the live wire de-energised
• Do not leave the machine until the line that has been touched or damaged has been
safely de-energised!
• Work on the electrical system may only be carried out by a technician with appropriate
training, in accordance with the applicable electrical engineering rules
• Inspect and check the electric equipment of the machine at regular intervals. Defects
such as loose connections or scorched cables must be rectified immediately
• Observe the machine’s operating voltage!
• Always remove the earthing strap from the battery when working on the electrical
system or when carrying out welding work!
• Starting with a battery jumper cable can be dangerous if carried out improperly.
Observe the safety instructions regarding the battery!
Gas, dust, steam, smoke
• Operate the machine only on adequately ventilated premises! Before starting the
internal combustion engine on enclosed premises, ensure that there is sufficient venti-
lation!
Observe the regulations in force at the respective site!
• Welding, burning and grinding work on the machine may only be carried out by a
Wacker Neuson dealer. Risk of fire and explosion!
• Before carrying out welding, flame-cutting and grinding work, clean the machine and its
surroundings from dust and other inflammable substances, and ensure that the
premises are adequately ventilated – danger of explosions!
• In areas with special hazards (e.g. toxic gases, caustic vapours, toxic environments),
wear appropriate protective equipment (breathing filters, protective clothing)!
Hydraulics
• Work on the hydraulic equipment of the machine must be carried out only by persons
having specific technical knowledge and experience in hydraulic systems!
• Check all lines, hoses and screw connections regularly for leaks and obvious damage!
Repair any damage and leaks immediately! Splashed oil can cause injury and fire
• In accordance with the Operator’s Manual/instructions for the respective assembly,
release the pressure in all system sections and pressure lines (hydraulic system) to be
opened before carrying out any implementing/repair work!
• Hydraulic and compressed-air lines must be laid and fitted properly! Ensure that no
connections are interchanged! The fittings, lengths and quality of the hoses must
comply with the technical requirements
