Maintenance
BS 600/BS 700
wc_tx000024gb.fm
28
6.3
Lubrication
See Graphic: wc_gr000054, wc_gr000046
6.3.1
Change ramming system oil after first 50 hours of operation and every
300 hours thereafter. To drain oil, remove plug (g) and tilt machine
back until it is resting on handle.
Note:
In the interests of environmental protection, place a plastic sheet
and a container under the machine to collect any liquid which drains
off. Dispose of this liquid in accordance with environmental protection
legislation.
6.3.2
With the rammer on a level surface, add oil through plug (e). Proper
ramming system lubrication is indicated when approximately 1/2-3/4 of
the sightglass (f) is full.
6.4
Shoe Hardware
See Graphic: wc_gr000055
On new machines, or after replacing shoe, check and tighten shoe
hardware (a) after the first 5 hours of operation. Inspect hardware
every week thereafter.
Torque hardware as specified.
