Wacker Neuson 803 Dualpower, Service Manual

Page: 93 / 196

SHB 803 en – Edition 2.4 * 803s314.fm
3-55
Maintenance
Cleaning the seat belt:
• Clean the seat belt (which remains fitted in the machine) with a mild soap solution only.
Do not use chemical agents as they can destroy the fabric!
Exterior of the machine
The following articles are generally suitable:
• High-pressure cleaner
• Steam jet
Engine compartment
Danger
!
Clean the engine only when it is at a standstill –
Injury hazard!
☞
Stop the engine before cleaning
Caution!
When cleaning the engine with a water or steam jet
☞ The engine must be cold
☞
and do not point the jet directly at electric sensors such as the oil pressure
switch.
The humidity penetrating any such sensors causes them to fail and leads to
engine damage!
Threaded fittings and attachments
All threaded fittings must be checked regularly for tightness, even if they are not listed in
the maintenance schedules. This applies in particular to:
☞
Engine fastening screws
☞ Fastening screws on the hydraulic system
☞
Bucket teeth and pin fastenings on the attachment
☞ Rollbar fastening screws
Retighten loose connections immediately. Contact a Wacker Neuson service center if nec-
essary.
Pivots and hinges
All mechanical pivot points on the machine (door hinges, joints, for example) and fittings
(door arresters, for example) must be lubricated regularly, even if they are not listed in the
lubrication plan.