Wacker Neuson 1000164553, Operator'S Manual

Page: 90 / 188

3-48
BA 1404 en – Edition 2.7 * * 1404b330.fm
Operation
3.28 Crane-lifting the machine
Safety instructions
• The crane and the lifting gear must have suitable dimensions
• Crane-lifting the machine requires suitable lifting gear
• Secure the machine against unintentional movement!
• Check the cab for damage.
Danger
!
Incorrect crane-lifting of the machine –
Accident hazard!
☞
Ensure that no one is in the machine!
☞
Have loads fastened and crane operators guided by experienced persons only!
The person guiding the crane operator must be within sight or sound of him
☞
Ensure that the crane and the lifting gear (cables, chains) have sufficient
lifting capacity!
☞
Raise the machine only if the standard bucket is empty
☞
Stay clear of suspended loads!
☞
It is essential that you read the safety instructions at the beginning of this
chapter and follow any other safety instructions relevant in your country!
☞
Ensure that the lifting gear has the required lengths L1, L2, L3 and L4 .
Caution!
Tighten the following screw connections to the specific torque before raising
the machine.
Retighten loose connections immediately. Contact an authorized workshop if
necessary
– see Threaded fittings and attachments on page 5-33.
☞
Tighten both screws A to 110 Nm (81 ft.lbs).
Abb. 113: Cab attachment on rear wall
A
A