Safety Information
LB 1
wc_si000219gb.fm
6
1.2
Safety Guidelines for Operating the Machine
Operator
training
Before operating the machine:
Read and understand the operating instructions contained in all manuals
delivered with the machine.
Familiarize yourself with the location and proper use of all controls and safety
devices.
Contact Wacker Neuson Corporation for additional training if necessary.
When operating this machine:
Do not allow improperly trained people to operate the machine. People
operating the machine must be familiar with the potential risks and hazards
associated with it.
Work area
When setting up the machine:
Keep the area immediately surrounding the machine clean, neat, and free of
debris.
When lighting traffic routes, always place one of the three support ropes at a
right angle to the traffic route to ensure that the machine does not fall into the
traffic route.
Cordon off the area around the tripod in areas with crowds of people.
Clearly mark support ropes so that the support ropes do not pose a hazard for
passersby.
Keep plugs and receptacles dry.
Keep a distance of at least one meter (3 feet) between the balloon and any
flammable material such as wood or plastic.
Keep the machine at least 5.5 m (16 ft.) from pools and spas.
Be sure the machine is on a firm, level surface and will not tip, roll, slide, or fall.
Make sure the area above the balloon is open and clear of overhead wires and
obstructions. High voltage cables should be at least 50 meters (160 feet) linear
distance away from the tripod. Overhead electric lines should be kept at least
2.5 meters (8 feet) away from the balloon.
When operating this machine:
Do not allow water to accumulate around the base of the machine. If water is
present, move the machine.
Do not operate the machine in areas where leaks of combustible substances
such as gasoline and natural gas may occur.
Do not use with extension cord near water or where water may accumulate.
Guidelines for
operating
When operating this machine:
Use on GFCI-protected circuits only.
Replace a damaged balloon cover before use.
Lower the tripod and collapse the balloon after use.