Wacker Neuson 0620340, Operator'S Manual, Page: 11 / 22

LB 1 Operation
wc_tx000741gb.fm
11
2.3 Setting up the Tripod
Prerequisites Tripod
Procedure Follow the procedure below to set up the tripod.
1. Unfold the tripod legs.
2. One of the legs has its own locking clamp (a) . If the ground is not level, loosen
this clamp and adjust the length of the leg so that the mast is vertical.
3. The mast should not touch the ground. Adjust the mast so that it is at least 6 cm
(2 inches) from the ground.
4. Adjust the braces (b) so that they are parallel to the ground.
The tripod is now ready for the balloon.
WARNING
Electric shock hazard. Electric shock can cause serious injury or death.
f
Never connect the light to its power source and never turn it on until it has been
fully unpacked and assembled to the tripod!
6 cm
(2 in.)
b