Wacker Neuson 0008060, Operator'S Manual

Page: 32 / 42

Maintenance WP 1540A/AW
wpm_tx001130gb.fm
30
5.9 Cleaning Sediment Cup
See Graphic: wc_gr000029
5.9.1 Turn the fuel valve off.
5.9.2 Remove the sediment cup (a) and the O-ring (b) .
5.9.3 Wash both thoroughly in a nonflammable solvent. Dry and reinstall
them.
5.9.4 Turn the fuel valve on and check for leaks.
5.10 Adjusting Engine Speed
See Graphic: wc_gr000280
Adjust to a full load speed of 3600 ± 100 rpm.
To adjust engine speed:
5.10.1 Place machine on a rubber test mat to prevent it from moving.
5.10.2 Start engine and allow it to warm up for a minute.
5.10.3 Turn throttle stop screw
(a) in to increase speed, out to decrease
speed. Make sure throttle lever is touching stop screw before
measuring RPM.
NOTICE :
Running plate at a speed higher than that listed in
Technical
Data
can damage both the plate and the engine.
wc_gr000280
a