DW Guillotine 208
46
Part No. 29-MAN-00, Rev. A
E.H. Wachs
C
LEANING AND
R
EMOVING THE
M
ACHINE
The DW 208 will be easier to clean if you leave it mounted
vertically on the pipe. Spray and lubricate the machine, then
remove it.
If the wire binds against the
pipe while retracting the bow,
start the machine to run the
wire while feeding the bow
back to the top.
Always have the HPU pow-
ered off when connecting and
disconnecting hoses, to avoid
fluid spills.
1.
Turn the feed handle to fully retract the bow all the
way to the top.
2.
Disconnect the hydraulic hoses from the machine.
3.
Turn the tensioning knob to take the tension off the
wire. Leave the wire mounted on the wheels.
4.
Release the latches on the front cover and the wire
channel covers, and open the covers.
You can use the coolant
sprayer to clean the machine.
5.
Spray all components thoroughly with water to wash
off cutting debris.
6.
Spray the following components with a water-displac-
ing lubricant (such as WD-40):
• feed screw
• guide rods.
7.
Hold the saw, or secure it with a support device, to
keep it from falling when you release the clamping
chain.
8.
Turn the chain clamping handle to release the tension
on the chain, until you can disconnect the pins from
the yoke.
9.
Wrap the chain around the storage pin on the frame,
and connect the strap to secure it.
NOTE
NOTE
NOTE
