WABCO OptiTire, System Description

Page: 51 / 72

51
Start-up
8 Start-up
8.1 Starting the Diagnostic Software
– Start the Diagnostic Software.
– Switch on ignition. Ensure power supply of trailer if necessary.
– Chose whether a guided selection should take place or the Diagnostic
Software should automatically search for connected ECUs.
8.2 Parameter setting
8.2.1 Reading in a parameter set
– This button can be used to read in a parameter set directly.
8.2.2 Selection/entry of parameter data
– Click the accompanying button if your wish to enter the parameters yourself.
Ö
The
Parameters
window is opened.
– Select whether the Module reception should be displayed or an Assignment
test should be carried out.
"Vehicle configuration" tab
– Enter the respective vehicle type and vehicle data .
– Select the vehicle configuration to use under System configuration .
If the vehicle is not included under the standard system configurations
a spare tire is used with the internal sensor, select the free System
configuration .
– Define the type and position of the axles for this free configuration.
– Select the Sensor type : Internal sensor (WIS) or External sensor (WM2) .
"Module configuration" tab
– Enter IDs of the sensors and tire pressure values (according to vehicle
manufacturer) in list of axes and wheels.
The following options are available for entering the IDs:
„
First option: Manual entry of the IDs
– Enter the number code on the barcode directly at the corresponding
wheel position.
„
Second option: Barcode scanner
– If you have stuck the barcode label onto a sheet of paper in accordance
with the vehicle configuration, you can scan in the values directly using a
barcode scanner.
„
Third option: Sensor assignment and stimulation