Vzense DCAM560C, User Manual

Page: 25 / 46

25
cable(Order NO. 814000600015), the standard RJ45 socket locates at the back of the
DCAM560 Lite camera;
3. Insert the DC connector of the power supply adaptor into the 12V DC Jack at the
back of the camera;
4. Connect the adaptor to power source;
5. Please do set the IP address of the camera and host PC in the same segment;
6. The default IP address of DCAM560 Lite is 192.168.1.101, you can change the IP
address by the VzenseConfigTool;
China
：
https://gitee.com/Vzense/VzenseConfigTool
Oversea
：
https://github.com/Vzense/VzenseConfigTool
Please do read the document before reconfigure the camera:
6.1.3 POE Mode Installation (For DCAM560C Pro)
What is PoE+ (Power Over Ethernet)
Power over Ethernet (PoE+) is a technology that lets network cables carry electrical
power. It simplifies the topology of the Ethernet system by reducing the dedicated
power cable, a PoE switch or injector shall be in use to support the PoE feature.
For Vzense DCAM560C camera, the POE Switch or POE injector needs to support
IEEE 802.3at-2009 standard also known as PoE+, which can provide up to 25.5W, or
IEEE 802.3bt-2018 standard also known as PoE++, which can provide up to 60W.
Otherwise the product may not work well at long range mode.
We can provide optional PoE switch or PoE injector to our customers, please try to
contact the sales for the quotation and more information.
Steps to Setup PoE Mode
As mentioned above, a PoE switch or PoE injector shall be in use to setup the PoE;
The steps are as below:
1. Mount the camera in an appropriate fixture, e.g. a camera bracket;
2. Plug one end of the Ethernet cable into the RK45 socket at the back of the camera,
and plug the RJ45 end into the Ethernet port of your PoE switch or PoE injector;