13
5
GND
GND
System ground
6
VDD
INPUT
5-9V power supply input
Hardware Trigger Function
Hardware trigger mode is available only when the camera works at slave mode, in
slave mode the camera will wait for the hardware trigger signal on Ext_Trigger.
The EXT_Trigger signal is to driver the MOSFET, External input trigger signal voltage
should range 3.3V-20V.
You can use input pin Ext_Trigger to send a hardware trigger signal to the camera.
The hardware trigger can be used to trigger the acquisition start.
A hardware
debouncer circuit shall be considered on the EXT_Trigger line.
By default, the hardware trigger is rising edge activated, refer to below exposure
timing:
T1
Exposure
Exposure
EXT_Trigger
Camera Exposure
T1
The requirement to T1 should be from 1us to 1ms.
Exposure_timing Pin Description
This pin is an output indicates the whole exposure period of the camera. The internal
circuit of this pin with a pull-up resistor 430
Ω
.The pull up voltage is 5V.
By default, the polarity is low level activated, which means a low-level signal indicates
the exposure period. Please refer to below figure:
4.2
Type B USB2.0 Connector
The camera supports Type B-USB 2.0 transmission.
