Part number 20073, Rev 0
4
INSTALLATION INSTRUCTIONS
UNCRATING
Move your refrigerator as close to the
final location as possible before
unpacking. Remove the carton and
the styrofoam strips. The location
should be as close as possible to the
power outlet so no extension cord is
needed.
LEVELING
You can level your unit with the screw-
type adjustable leveling legs on the front corners of the unit. Turn counterclockwise to raise
the corner; turn clockwise to lower it. Leveling legs are required in front only. Unit may
have a slight tilt from front to back. This is acceptable and is recommended on this unit.
POWER SOURCE
The supply circuit to this cabinet must
conform to all National and Local
Electrical Codes. Consult the cabinet
Serial-Data plate for voltage, cycle,
phase, and amp requirements before
making
connection.
VOLTAGE
SHOULD NOT VARY MORE THAN 5%
FROM SERIAL PLATE RATINGS. A
separate circuit is recommended to prevent possible loss of
product due to over-loading or failure of other equipment on the
same circuit. PROTECT THE CIRCUIT WITH A 20 AMP DELAY-TYPE
FUSE OR CIRCUIT BREAKER. Do not use an extension cord. Be
sure your unit is properly grounded. Use the 3-prong plug
provided into a 3-prong grounded outlet. (Only this method
complies with national electrical codes, local codes and
ordinances.) Unless the above grounding method is followed, you
are not protected against severe or lethal shock in the event of a
short circuit of an electrical component or wiring of the unit.
