VWR General Purpose Refrigerators and Freezers
Installation | 9
Installation Instruction for
25LCEEVWA
Door Seal
CAUTION:
Door seal integrity is critical for
refrigerators and freezers. A loose fitting gasket
allows moist air to be drawn into the cabinet,
resulting in quicker frost build-up on the
evaporator coil, longer running time, poor
temperature maintenance, and increased
operation cost.
To check the door seal, complete the following steps:
1. Open the refrigerator door.
2. Insert a strip of paper (a couple of inches wide) between
the door gasket and the cabinet flange and close the
door.
3. Slowly pull the paper strip from the outside. You should
feel some resistance.
4. Repeat this test at 4 inch intervals around the door. If the
door does not seal properly, replace the gasket.
5. Check the freezer door seal, repeating steps 1 to 4.
Rearranging the Shelves
Shelves in the refrigerator compartment are adjustable.
To remove:
1. Remove all items from the shelf.
2. Tilt the shelf up at the front.
3. Lift the shelf up at the back and bring the shelf out.
Refrigerator Compartment
To replace:
1. While tilting the shelf up, insert the top hook at the back
of the shelf in a slot on the track.
2. Lower the front of the shelf until the bottom of the shelf
locks into place.
Adjustable Bins on the Door
Adjustable bins can easily be carried from refrigerator to work
area.
To remove:
•
Lift bin straight up, then pull out.
To replace or relocate:
•
Slide in the bin just above the molded door supports, and
push down. The bin will lock in place.
The snugger helps prevent tipping, spilling or sliding of small
items stored on the door shelf. Grip the finger hold near the
rear of the snugger and move it to fit your needs.
Non-Adjustable Bins on the
Door
