1
VUTEC CORPORATION
2741 N.E. 4
th
Avenue
Pompano Beach, FL 33064
TEL: (954) 545 9000 - FAX: (954) 545 9011
E-MAIL:
LectricI&III-Rev E 06/18/2008
INSTALLATION INSTRUCTIONS
Lectric I $ III Screen
PLEASE READ THESE IMPORTANT SAFETY INSTRUCTIONS
•
Read and understand all instructions before installing and using.
•
Close supervision is necessary when Projection Screen is used by or near children. Do not leave Screen unattended while
in used.
•
Installer must ensure that the mounting structures and fasteners must be of adequate strength to securely support the
screen so that vibrations or even abusive pulling on the screen surface will not cause the housing to work loose or fall.
•
The Screen is provided with toggle Switch that needs to be installed and wired by a qualified service man following the
wiring diagram shown in Operation section of this manual. Wiring must conform to local and/or national electric codes
and regulations.
•
Do not operate Screen with a damage cord or if the Screen has been dropped or damage – until it has been examined by a
qualified serviceman.
•
DO NOT place or attach anything to metal casing or viewing screen.
•
Position cord so that it will not be tripped over, pulled, or contact hot surfaces.
•
DO NOT plug the cord in with wet hands; electric shock could occur
•
DO NOT under any circumstances cut or remove the third (Ground) prong from power cord. For personal safety, this
Projection Screen must be properly grounded.
•
To reduce the risk of electric shock, do not dissemble this Projection Screen, but take it to a qualified serviceman when
service or repair is required. Incorrect reassembly can cause electric shock when Screen is used subsequently,
•
If an extension cord is necessary, it is absolutely necessary that it is UL-Listed, 3-wire grounding type appliance
extension cord having a grounding type plug and outlet. The electrical rating of the extension cord must be equal or
greater that the rating of the projection screen.
•
The use of an accessory attachment not recommended by the manufacturer may cause a risk of fire, electric shock, or
injury to persons.
“SAVE THESE INSTRUCTIONS”
