NOTCH
RIB
ARM
PIN
Installation is very simple. However, we do.
encourage you to closely follow these instructions.
1.
Let’s begin by removing the plastic bag containing the Liberator and the two flat panel
monitor stands.
2.
On the bottom of each stands is a plastic bag with 5 rubber feet ( you only need 4!).
Carefully remove the feet and install according to the enclosed instructions.
Figure 1
3.
You can use one or both of the stands. Stack them and place them under your flat panel
monitor (see Figure 1)
4.
You can also have an ingenious document support system… The Liberator. It may be
attached to any of the four (4) positions: 2 holes in the front, 2 in the back…
a)
Gently slide the arm through the hole in the Liberator. Note: Rib on top of arm MUST Figure 2
Align with notch in hole of Liberator. DO NOT force (see Figure 2).
b)
Insert arm pin into any of 4 holes in the stand. Depending on which side you prefer,
you might need to repeat step 1 above..
c)
Your Liberator has two slots for papers, documents, lists, messages, etc. You may
easily adjust the Liberator angle or pivot it when not in use.
Figure 3
VUR 8877FL
INSTALLATION INSTRUCTIONS
