18
Appendix
California Energy Commission battery charging testing
instructions
This telephone is set up to comply with the energy-conserving standards right out of the box. These
instructions are intended for California Energy Commission (CEC) compliance testing only. When the
CEC battery charging testing mode is activated, all telephone functions on the cordless handsets,
except battery charging, will be disabled.
To activate the CEC battery charging testing mode:
1. When the phone is not in use, press and hold
FLASH
on the telephone base for about 4 seconds
until it shows
Deregister all handsets?
.
Then, release the button.
2. Press the
YES softkey to continue. You hear a confirmation tone from the telephone base.
3. The telephone base displays
PLEASE WAIT...
. All system handsets show
Out of range OR no power
at base for a few seconds, and then you hear a confirmation tone from the handset.
When the phone successfully enters the CEC battery charging testing mode, all handsets
show
Press [HOLD] on base for 4 sec, then press [#] on handset
.
When the phone fails to enter this mode, repeat all the steps mentioned above.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, then plug it back in. The
telephone base is powered up as normal.
2. Register your handsets back to the telephone base. See page 135 for handset registration
instructions.
BC