VRmagic Eyesi, Installation And Operating Manual, Page: 19 / 80

4.2 Assembling the Support Feet and Lifting Column
Fig. 2: Pushing the support feet into the receptacles and tightening the screws
Assembling the support feet and lifting column:
1. Place the lifting column upright on the floor (
Â
see figure above).
2. Push the angled support feet into the corresponding receptacles as far as they
will go (
 see figure above).
3. Using a 5 mm hexagon key, tighten the four screws on the receptacles.
4. Make sure that the support feet are secured and cannot be moved.
5. Make sure the unit is appropriately aligned. If necessary, adjust the leveling
feet under the support feet until the unit is leveled and does not wobble.
NOTICE
Possible damage to the device if not leveled properly
The weight of the lifting column cannot be carried by the support feet alone; it
must not be „floating“ over the floor.
f
After adjusting the leveling feet, verify that the lifting column is in complete
contact with the floor.
4.3 Installing the Operating Table
Installing the operating table:
1. Turn around the operating table so that the mounting plate faces upwards.
2. Take two supplied M6 x 25 mm screws and screw them into the two holes
of the mounting plate closer to the large rectangular notch in the table. Leave
them standing out about 15 mm (
 see following figure).
3. Place the operating table’s mounting plate on top of the matching plate on the
lifting column. Make sure the M6 x 25mm screws are placed in front of the
two slots in the lifting columns mounting plate.
19
Installation
Eyesi Surgical Simulator – Installation and Operating Guide