VZR.2515.001IM
CUBE C-05 tripod turnstile
Installation Manual
29
NO and COMM
– normally open connection, NC and COMM – normally
closed connection.
Triggering of one of the terminal groups indicates that a pass has been
made in appropriate direction (PassOk1 - to the right, PassOk2 - to the left). The
dry contact closes/opens when the barrier arm is rotated at an angle of 60
degrees and returns to its original position after complete passage.
The AP dry contact relay output for the ACS is also installed on the control
board. Its terminals (NC, NO and COM) close or open when somebody is passing
either side through the turnstile. When the turnstile enters the AP mode (pass
counting mode), the D9 diode lights up at each pass.
The NC, NO and COM terminals are permanently closed or open in the
hold mode and the D9 diode is constantly on.
– LEDs are installed on control board to monitor its operation.
1)
D11 is indicative of a pass to the right and relay activation (PassOk1
– to the right).
2)
D10 is indicative of a pass to the left and relay activation (PassOk2
– to the left).
3)
D9 is either constantly on and indicative of the AP command activation (in its hold
mode). Or D9 is indicative of each pass (in the pass counting mode). It can be
selected by mode 7 (according to Table 1).
