APSPS1_RevA_1/19
2
Detailed Descriptions:
Wire Harness Colors and Functions
2. YELLOW – Ignition Input (+)
The YELLOW wire connects to the vehicle's primary ignition wire. This wire will be used for system programming and
override.
Verification:
This ignition wire registers 12-Volt (+) when the key is in the accessory, ignition, and start positions.
Note:
Before making this connection, remove all module fuses until the system is completely connected.
1. RED – 12-Volt Input (+)
The RED wire connects to the vehicle’s primary 12-Volt (+) wire to power the system.
Verification:
The power wire registers 12-Volt (+) at all times.
Note:
Before making this connection, remove all module fuses until the system is completely connected.
Main Harness
See page 12 for the full system diagram.
4. WHITE/RED – Parking Light Relay Input (Internal Relay 30A Pin 87)
The WHITE/RED connects to vehicle 12-Volt (+) or Ground (-) to supply the relay output (WHITE wire).
Verification for default setting:
•
If the vehicle parking light wire registers 12-Volt (+) when the park lights are on, connect the WHITE/RED wire to a
constant 12-Volt (+) vehicle wire.
•
If the vehicle parking light wire registers Ground (-) when the park lights are on, connect the WHITE/RED wire to a
reliable vehicle ground source.
5. WHITE – Parking Light Relay Output (Internal 30A Relay Pin 30)
At its default setting, the WHITE wire supplies 12-Volt (+) or Ground (-) to the vehicle's park light wire based on the
connection of the relay input (WHITE/RED wire).
Verification:
The vehicle parking light wire registers 12-Volt (+) or Ground (-) when the park lights are turned on.
3. BLACK – Ground Input (-)
The BLACK wire connects to a reliable vehicle ground (-) source to power the system.
Verification:
The vehicle ground (-) source wire registers ground (-) at all times.
Note:
Before making this connection, remove all module fuses until the system is completely connected.
6. BLACK/YELLOW – Starter Kill Input / Output (Internal Relay 30A Pin 87A)
The BLACK/YELLOW wire is used to interrupt the vehicle's starter wire when the alarm system is triggered. Locate and cut
the vehicle's starter wire. Attach the BLACK/YELLOW wires to each end of the vehicle's cut starter wire.
Verification:
The vehicle's starter wire registers 12-Volt (+) or Ground (-) during engine crank.
8. PURPLE/WHITE – Loop Trigger Output (-)
The PURPLE/WHITE wire is used as a Loop Alarm Trigger. If the loop is closed (Connected) when the alarm is armed, the
alarm will trigger if the loop is opened (Disconnected). If the loop is open when the alarm is armed, the Loop Trigger will
be ignored. This can be used to protect the user's helmet or other personal belongings.
7. BLACK/YELLOW – Starter Kill Input / Output (Internal 30A Relay Pin 30)
The BLACK/YELLOW wire is used to interrupt the vehicle's starter wire when the alarm system is triggered. Locate and cut
the vehicle's starter wire. Attach the BLACK/YELLOW wires to each end of the vehicle's cut starter wire.
Verification:
The vehicle's starter wire registers 12-Volt (+) or Ground (-) during engine crank.
