APPS1_RevA_1/19
11
Quick Reference:
System Programming & Diagnostics
Bank 2: Security Options
See pages 5-7 for detailed descriptions.
1 Chirp
2 Chirp
3 Chirp
4 Chirp
5 Chirp
6 Chirp
7 Chirp
8 Chirp
1 Auto Arming
OFF
ON
2 Anti Hi-Jacking
OFF
ON
3 Tilt Sensor Level
1
5
15
30
4 Silent Mode
OFF
ON
5 Security Notification
Siren
Horn
6 Parking Light Output
ON
OFF
7 Shock Sensor Level
1
2
3
4
5
6
7
8
8 Aux Ch.3 Output
1sec Pulse
Latch ON/OFF Latch Until IGN
9 Override Method
Default
Custom Code
10 Default All Features
OFF
ON
Feature Bank 2
Fe
at
ur
es
Options
Adjusting the Shock Sensor
1. Arm the system, wait 5-10 seconds, then with an open palm carefully apply impact to areas of the vehicle to test the
shock sensor’s sensitivity.
2. To adjust, enter Feature Bank 2 - Feature 7. 1 = Low ; 8 = High.
3. If the proper sensitivity still cannot be achieved, re-locate the shock sensor.
Troubleshooting Trigger Zones
Test the doors, hood, trunk, and shock sensor to ensure they trigger the security system. Once triggered, the Parking
Lights flash to indicate the trigger source:
4 Tilt / Shock
5 Addi
�
onal Sensor
6 Loop Input
7 Igni
�
on Input
Bank 1: Add / Remove Remote Controls
To Auto Program a remote control:
1. Cycle the ignition key to ON 5x, Ending in ON.
2. The system will beep one (1) time, indicating you have accessed Bank 1, Remote Control Programming.
3. Press the ARM button of each remote control you wish to program. The system will beep to indicate the remote
control is programmed.
4. Turn the ignition key to OFF to exit programming mode, or cycle the ignition key OFF/ON to advance to the next
Feature Bank.
To delete a remote control:
This system will store a
maximum of four (4) remote controls
in the memory. Additional programmed remote controls
will delete the oldest-programmed remote control.
Remote control programming is located in Feature Bank 1. This system will Auto Program all remote control functions.
