Vox Lil Looper, Owner'S Manual

Page: 29 / 100

29
Controlling the Lil’ Looper with a foot switch
If an effect or parameter value that has been saved
in advance is changed, the EFFECT button will
blink.
3.
Hold down the EFFECT button.
The effect has been saved if the EFFECT button
blinks, then lights up.
Controlling the Lil’ Looper with a
foot switch
When the optional VOX VFS2 foot switch is connected
to the EXT.SW jack, it can be used to control the loops
and effects.
Be sure to connect the VOX VFS2 foot switch
while the power is turned off. Connecting or
disconnecting the foot switch while the power is
on can cause a malfunction or damage to the unit.
Do not press the switches of the VOX VFS2 foot
switch simultaneously. Doing so can cause a
malfunction.
1.
Hold down the EFFECT button and the AUTO
REC button for 2 seconds.
Each time the button is pressed, the setting will be
switched. If the setting is switched, the AUTO REC
button and METRONOME button will blink or
light up to indicate what can be controlled.
Blinks red
→
Lights up
→
Does not light up:
Controls the effects with the foot switch.
Blinks green
→ Lights up → Does not light up:
Controls the loops with the foot switch.
Controlling an effect (set at the factory)
You can switch an effect on or off with switch 1 and
select the effect type with switch 2.
The function for controlling an effect with the foot
switch is set at the factory.
Controlling a loop
You can stop the playback and delete the data of each
loop. Switch 1 corresponds to Loop 1 and switch 2 to
Loop 2.