By default, the generator sets the "sine" waveform. For Wellness sessions, professor
Mishin recommends only this form of signal. For experimental purposes, you can change
the waveform (sine / meander) from the generator panel. To switch, press and hold the
"TIMER" button for at least 5 seconds until a short beep sounds. The led display on the
front panel of the generator will indicate:
- blinks at a frequency of approximately 1 time per second-sine;
- continuously glowing-meander.
6… Disable and save generator parameters
Switching off is performed by pressing and holding the "POWER" button for at least 2
seconds – the device will turn off and go into standby mode.
In addition, the generator can be turned off by disconnecting from the power grid.
The device can also be switched off automatically:
- at the end of the set timer;
– when the generator does not find/lose the resonance frequency (for example, when the
electrical connection is broken, or when the electrical quality of the connected coil is
extremely low).
After any change of parameters using the buttons on the generator panel, new values
(power, timer, waveform) are written to the non-volatile memory of the generator
microcontroller in 20 seconds. The same thing happens when the generator is turned off
by pressing and holding the "POWER" button» for at least 2 seconds. The next time you
turn on the generator, it will start working with exactly the parameters that were set in the
previous session.
7… Working with coils in different modes
1 mode: low-voltage capacitive
This is the standard mode of using Mishin coils. In this version, the coils (torus or flat
disk) are connected directly to the generator using an XLR-USB cable. In this mode, both
a flat universal coil and a capacitive torus (bagel) coil can work.