23 Point Henry Road
MOOLAP VIC 3224, Australia
T +61 3 5248 5809
www.VorOtek.com
Technical Manual
Technical Manual
SCOPE
SCOPE
Troubleshooting
LED illumination cuts out and resets repeatedly
•
The LED illumination does not fade, but the protective
circuit breaker keeps switching off (and resetting)
when the Power Pack requires recharging. See section
on ‘Charger’.
•
LED’s rarely need replacing, but if this is necessary it
must be done by VorOtek.
Power Pack will not charge
•
See section on ‘Charger’.
SpecFrame damage
•
Most problems can be dealt with by an optometrist
e.g. missing screws, new nose pads and bent frames
•
For SpecFrame replacement contact VorOtek.
For all other questions contact VorOtek.
Cleaning
•
Unplug the VorOtek Scope or Light from power source
prior to cleaning.
•
Visually inspect the VorOtek Scope or Light for soiling.
•
Remove all visible soiling by first wiping external
surfaces & cables with a soft cloth slightly dampened
with mild detergent and water (mixed to the
manufacturer’s instructions).
•
Wipe all external surfaces*, including Headband
model leather covers & velcro straps using a soft cloth
slightly dampened with 70% isopropyl Alcohol (IPA).
*SpecFrame model cables should be wiped with a
hospital approved disinfectant wipe.
•
Allow all surfaces to air dry for at least 60 seconds.
•
Re-wipe all surfaces with a lint free soft cloth to
remove any residue from cleaning products.
•
Ensure all surfaces & cables are dry before operating
the VorOtek Scope or Light.
•
Caution: Do not immerse or saturate any component
of the VorOtek Scope or Light in a cleaning solution.
•
Caution: Do not autoclave any component of the
VorOtek Scope or Light.
Maintenance
•
Before every procedure, carefully inspect the
VorOtek Scope or Light to ensure it is fully functional.
DO NOT use if inspection reveals any damage.
•
The VorOtek Scope & Light Range does not require
any other routine maintenance.
•
For repair or warranty, refer to the support & repair
page on VorOtek’s website.
Warranty
•
Scopes & Lights
- 3 years for any component defect
or manufacturing failure.
•
Power Pack
- 18 months for any component defect or
manufacturing failure.
•
Warranty does not cover abuse, misuse or transit
damage.
•
Please contact VorOtek prior to sending for repair.
Notices & Precautions
•
Should a serious incident occur while using the device
please report the incident to the manufacturer
(VorOtek) and the competent authority of the
Member State in which the user and /or patient is
established.
•
Only to be used by qualified health professionals.
•
Do not use in the presence of flammable
anaesthetics.
•
Do not expose electrical equipment to liquids or
excessive moisture.
M
M
IFU-003-M Scope TechMan-R5
