5
MEDIAPLAYER
A. SD CARD CONNECTION
For connection of a SD CARD with MP3 files
B. USB CONNECTION
For connection of a USB stick with MP3 files
C. DISPLAY
Shows MP3 information
D. MODE
Select playing from USB stick, SD card or Bluetooth
E. PREV
Play previous track
F. NEXT
Play next track
G. REPEAT
Track repeating
H. PLAY/PAUSE
Track play or pause mode
HOW TO CONNECT WITH YOUR BT DEVICE:
First turn on the speaker, then press on “MODE” (D) till you see “AUX”. Then use your mobile or computer to search a BT-
device. When you find the
“
BT-STREAM
”
then connect. The password is: 0000
TROUBLESHOOTING
One certain method of determining if a speaker is faulty is to substitute a speaker that is known to work correctly for
the suspected problem speaker. If the “normally correct speaker” is experiencing the same difficulties or problems
as the suspected problem speaker, use the information below to isolate the problem.
Problem
Possible cause
Action
No output
Cables
Reseat all connectors
Substitute known good cables
Check solder joins
Inspect cable for damage
Inspect wire or connector for stray strand that may short
Intermittent
Poor connections
While it is possible for a faulty speaker to exhibit intermittent output,
it’s more likely that an output cable/connector is the problem. Check
the soldering on your connectors.
Constant noise,
buzzing and/or
humming
Faulty electronic
Any constant noise originates in the amplifier, mixer, signal
processing, source device in the signal devices, or line-level wiring.
Check and correct system grounding as required. Chain check for
noisy sources or electronic components. Check wiring for shielding.
Poor low-
frequency output
Improper polarity
When two speakers in close proximity to each other are connected
out-of-polarity, they can partially cancel each other out, especially at
low frequencies. Check your speaker cables to be sure they are all
identically wired and connected. Check the balanced line signal
cables to be sure they are all correctly wired.
Summary of Contents for 170.344
Page 2: ...2...