VONROC PH513AC, Original Instructions Manual

Page: 8 / 76

8
EN
WWW.VONROC.COM
- 100 cm to a flammable ceiling or roof;
- 50 cm to the side walls
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm
2
. If you use an extension
cable reel, always fully unroll the cable.
2. MACHINE INFORMATION
Intended use
This product is designed as a patio heater for
domestic environments. The heater is intended for
private gardens or other outdoor areas at home.
The heater may not be used to heat an indoor
space, usage as a non-household outdoor space
heater or for the drying of textiles or other mate-
rials. This heater is not equipped with a device to
control the room temperature so do not use this
heater in spaces when they are occupied by per
sons not capable of leaving the room on their own,
unless constant supervision is provided. The device
is to be used only for its prescribed purpose. Any
other use is deemed to be a case of misuse.
TECHNICAL SPECIFICATIONS
Model No. PH513AC
Voltage 220–240 V ~
Frequency 50 Hz
Power 2000W
Power settings 1: 800W
2: 1200W
3: 2000W
Height 225cm
Baseplate diameter Ø 47cm
Heating element type Halogen
Heating time 3-5 second
Heating distance 3m
Heating area 9m²
Colour temperature 3000-3500K
Tip-over safety switch Yes
Ingress protection class IPX4
Protection class Class I
Weight 14.1 kg
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-5.
1. Heater
2. Protective grill
3. On/off switch
4. Upper tube
5. Middle tube
6. Lower tube
7. Cover
8. Feet
9. Baseplate
10. Left on/off switch
11. Right on/off switch
12. Power cable
13. Cable connector box
14. Cable holder
15. Baseplate bracket
16. Bolt
17. Nut
18. Long screw
19. Short screw
20. Sleeve anchor
3. ASSEMBLY
This heater should be installed by a compe-
tent person, i.e. a qualified electrician.
Always disconnected the heater from the
electrical supply and allow it to cool before
installation.
Assembling the heater (Fig. B­G)
Always mount the device with the supplied
accessories.
Before starting to assemble the device, take the
following into consideration:
• Place the device on a firm, level surface. The
device may never be placed at an angle!