EN
9
WWW.VONROC.COM
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable
for the power rating of the machine with a
minimum thickness of 1.5 mm
2
. If you use an
extension cable reel, always fully unroll the
cable.
• If the supply cord of this power tool is damaged,
it must be replaced by a specially prepared
supply cord available through the service
organization.
2. MACHINE INFORMATION
Intended use
Your angle grinder has been designed for grinding
masonry and steel materials without the use of
water. For cutting, a special protection guard must
be used (not included). Fig. D2.
Not suitable for construction site usage.
TECHNICAL SPECIFICATIONS
Model No.
AG506AC
Mains voltage
220-240V~
Mains frequency
50/60Hz
Power input
2600W
No-load speed
6500 /min
Grinding disc
Diameter:
Bore:
230 mm
22.2 mm
Spindle thread
M14
Weight
6.7 kg
Sound pressure level L
PA
96.1 dB(A), K=3dB(A)
Acoustic power level L
WA
107.1 dB(A), K=3dB(A)
Vibration “Surface grinding” a
h,AG
7.86 m/s2, K=1.5 m/s2
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN 60745-1 an
EN 60745-2-3; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned.
• the vibration emission during actual use of the
power tool can differ from the declared total
value depending on the ways in which the tool
is used;
• need to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such
as the times when the tool is switched off and
when it is running idle in addition to the trigger
time).
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keep-
ing your hands warm, and organizing your work
patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-4.
1. Spindle lock button
2. Allen screw
3. Protection guard
4. Carbon brush cover
5. On/Off switch
6. Side handle connection point
7. Side handle
8. Allen key
9. Rear handle
10. Spindle
11. Mounting flange
12. Wheel disc (not included)
13. Clamping nut
14. Spanner
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
