*941093-00*
941093-00
CONTROL AND MOUNTING
STUD POSITIONS
TO INSTALL CYLINDER
Rim
cylinder
Cylinder
bracket
Cylinder screws
(cut to length)
Rim
cylinder
Cylinder
bracket
Cylinder screws
(cut to length)
UP
UP
RHR
Out
side
Lock
stile
LHR
Outsid
e
Lock
stile
Note
stud
positions
Note
stud
positions
RHR
Out
side
Lock
stile
LHR
Outsid
e
Lock
stile
1
Prepare door for exit device.
See exit device instructions for locations of holes, backset
(line X-X) and center lines.
2
Prepare door for control:
2a Transfer line X-X from inside (exit device) side of door
to outside (control side) of door. Use extra care if edge
of door is beveled. Be sure line X-X is parallel to edge
of door.
2b Locate and prepare holes as shown on other side.
3
Prepare control:
3a Orient control as shown for your application (RHR or
LHR) and make sure mounting studs are in positions
shown. If not, move mounting studs to correct
positions.
3b Install cylinder.
3c If necessary, adjust tailpiece length.
4
Apply exit device and control.
To Adjust Tailpiece Length
Cut cylinder tailpiece as shown.
1/8”
Inside face
of door
Cylinder
tailpiece
Cylinder Control
388NL
Installation Instructions