Volvo XC60 Twin Engine 2020, Owner'S Manual

Page: 606 / 714

LOADING, STORAGE AND PASSENGER COMPARTMENT
* Option/accessory. 604
Using electrical sockets
12 V sockets can be used for various acces-
sories designed for this, such as music play-
ers, cooler boxes and mobile phones.
High-voltage sockets
*
can be used for various
accessories designed for this, such as charg-
ers and portable computers.
For the sockets to supply current, the car's
electrical system must be set in the lowest
ignition position
I . The sockets are then active
as long as the starter battery level does not
become too low.
If the engine is switched off and the car is
locked, the sockets are deactivated. If the
engine is switched off and the car is not
locked, or is locked with double lock tempo-
rarily deactivated, then the sockets continue to
be active for a further seven minutes.
NOTE
Remember that use of the electrical socket
with the engine switched off entails a risk
of discharging the starter battery, which
can limit functionality.
Accessories that are connected to the elec-
trical sockets may be activated even when
the car's electrical system is disconnected
or if preconditioning is used. For this rea-
son, disconnect the connectors when they
are not in use in order to avoid the starter
battery being discharged.
WARNING
•
Do not use accessories with large or
heavy connectors - they can damage
the socket or come loose when driving.
•
Do not use accessories that can cause
interference to the car's radio receiver
or electrical system for example.
•
Position the accessory so that it is not
at risk of injuring the driver or passen-
gers in the event of heavy braking or
collision.
•
Keep an eye on connected accessories
as they can generate heat that can
burn passengers or the interior.
Using 12 V sockets
1. Remove the blanking plug (tunnel con-
sole) or fold down the cover (cargo area)
in front of the socket and plug in the
accessory's connector.
2. Unplug the accessory's connector and
refit the blanking plug (tunnel console) or
fold up the cover (cargo area) when the
socket is not in use or if the socket is left
unattended.
IMPORTANT
Maximum socket output is 120 W (10 A)
per socket.
Using high-voltage sockets
1. Pull down the socket cover and insert the
accessory's plug.
> The LED
2
lamp on the socket indicates
the status.
2. Check that the lamp is illuminated with a
steady green light - only then is current
available at the socket.
2 LED (Light Emitting Diode)