Volvo XC60 Twin Engine 2020, Owner'S Manual

Page: 506 / 714

STARTING AND DRIVING
* Option/accessory. 504
Fitting and removing the towing
eye
Use the towing eye if the car shall tow
another vehicle. The towing eye is screwed
into a threaded socket behind a cover on the
right-hand side of the rear bumper.
NOTE
If the car is equipped with a towbar, there
is no rear mounting for a towing eye.
Fitting the towing eye
Take out the towing eye from the foam
block under the floor in the cargo area.
Remove the cover – press on the marking
with a finger while you fold out the oppo-
site side/corner.
> The cover pivots around its centre line
and can then be removed.
3. Screw in the towing eye until it reaches its
end stop.
Screw the eye in firmly. For example,
thread through the wheel bolt wrench
*
and
use it as a lever.
IMPORTANT
It is important that the towing eye is firmly
screwed into place - right in until it stops.
Removing the towing eye
–
Unscrew and remove the towing eye after
use and return it to its place in the foam
block.
Finish by refitting the cover onto the
bumper.