Volvo V 90 Cross Country, Owner'S Manual, Page: 167 / 594

INSTRUMENTS AND CONTROLS
}}
* Option/accessory. 165
1. Depress buttons 1 and 3 on HomeLink
®
and
hold them depressed until the indicator lamp
begins flashing green (about 10 seconds).
2. Release the buttons.
> HomeLink ®
is now set to "learn mode"
and is ready to be reprogrammed; see the
section "Programming HomeLink
®
"
above.
Programming individual buttons
To reprogram an individual HomeLink
®
button,
proceed as follows:
1. Depress the required button and do not
release .
2. After approx. 20 seconds when the indicator
lamp on HomeLink
®
starts to flash yellow,
start with step 1 from the section "Program-
ming HomeLink
®
" above.
Note: If the button to be reprogrammed is
not programmed with a new unit, it will
resume the previously saved programming.
For more information or to provide feedback
about HomeLink
®
, visit www.HomeLink.com,
www.youtube.com/HomeLinkGentex or call the
toll-free number 00 8000 466 354 65 (or the
toll 49 6838 907 277).
Related information
•
HomeLink
®
*
(p. 162)
Trip computer
The car's trip computer records and calculates
vales such as e.g. distance, fuel consumption
and average speed whilst driving.
In order to facilitate fuel-efficient driving, informa-
tion is recorded about both instantaneous and
average fuel consumption. The information from
the trip computer can be shown in the driver dis-
play.
12-inch driver display.
8-inch driver display.
The following meters are included in the trip
computer:
•
Trip meter
•
Odometer
•
Instantaneous fuel consumption
•
Distance to empty tank
•
Tourist - alternative speedometer
Trip meter
There are two trip meters, TM and TA.
TM can be reset manually and TA is reset auto-
matically if the car is not used for at least four
hours.
The following information is registered while driv-
ing: