Volvo 1991 740 Model
When replacing tires, be sure that the new tires are the same size designation, type (radial) and
preferably from the same manufacturer, on all four wheels. Otherwise there is a risk of altering the car's
road-holding and handling characteristics.
NOTE: When storing wheel/tire assemblies (e.g. winter tires and wheels), either lay the assemblies on
their sides or suspend them off the ground. Laying wheel/tire assemblies on their sides for prolonged
periods can cause wheel and/or tire damage.
pg. 5:3 Wheels and tires (cont.)
Wear indicator
The tires have a so-called "wear indicator" in the form of a number of narrow strips running across or
parallel to the tread. When approx. 1/16" (1.6 mm) is left on the tread, these strips show up and indicate
that the tire should be replaced.
Tires with less than 1/16" (1.6 mm) tread have a very poor grip in rain or snow.
When replacing worn tires, it is recommended that the tire be identical in type (radial) and size as the
one being replaced. Using a tire of the same make (manufacturer) will prevent alteration of the driving
characteristics of the vehicle.
To improve tire economy:
●
Maintain correct tire pressure.
●
Drive smoothly: avoid fast starts, hard braking and tire screeching.
●
Tire wear increases with speed.
●
Do not change wheel location unless necessary.
●
Correct front wheel alignment is very important. Unbalanced wheels impair tire economy and driving
comfort.
●
Unbalanced wheels impair tire economy and driving comfort.
●
Hitting curbs or potholes can damage the tires and/or wheels permanently.
Flat spots
All tires become warm during use. After cooling, when the vehicle is parked, the tires have a tendency to
distort slightly, forming flat spots. These flat spots can cause vibrations similar to the vibrations caused
by imbalanced wheels.
They do, however, disappear when the tire warms up. The degree to which the flat spots form depends
file:///K|/ownersdocs/1991/1991_740/91740_11.htm (2 of 5)12/30/2006 8:58:00 AM
