Davide e Luigi Volpi S.p.A.
Via San Rocco,10 – 46040 Casalromano (MN) – Italy
Tel. +39 0376.76009 - 76012 Fax. +39 0376.76408
www.volpioriginale.it
e-mail:
____________________________________________________________________________________________________________________________________________
DAVIDE E LUIGI VOLPI S.p.A. - via San Rocco,10 - 46040 CASALROMANO (MN) – ITALIA YLBSVEA_4 LIBRETTO D’USO DINAMICA
26
To recharge the battery proceed as follows:
make sure the power supply network tension is the same as reported on the battery charger plate;
connect the battery charger with an electric socket being suitable and electrically protected;
insert the battery charger plug in the special "C" battery-charger socket placed in the front area at the
lower machine part.
o
Lights the pilot lamp, the battery is down.
o
Blinks the pilot lamp, the battery is charged.
To completely recharge the battery, when the latter is totally down, approximately 7 hours are needed.
Once the charge operation is finished, disconnect the battery charger from the power supply network and
after that from the machine.
The battery life mostly depends upon some basic rules:
•
do not short-circuit the battery;
•
promptly recharge the battery in a due time;
•
to recharge only use the battery charger supplied with. In no case, a battery charger different from the
supplied one shall be used;
•
never operate the machine when the battery charger is connected;
•
the battery shall be recharged and kept at a temperature between 5 and 40° C;
•
in case of a long period of storage/standstill, store the machine with a fully charged battery and
recharge
the battery every four months
. A non-recharge of the battery for a period exceeding four months could
cause its irreversible wear with a consequent, premature battery replacement;
•
when the battery cannot be recharged, at all, it shall be replaced through a battery having the same features
and dimensions and at the same time, the polarity of the connections shall be followed; to dispose of
batteries, turn to an authorized point of disposal.
6.3 BATTERY REPLACEMENT
•
Following the page 3 instructions, it is possible to extract the battery from the bottom of the machine and
replace it with a new battery.
•
For the replacement operations, please follow the numbered steps on page 3 in the correct sequence.
•
The machine will be completely empty and switched off before the replacement operation.
•
The second battery is optional.
7
TROUBLES - CAUSES - CURE
TROUBLES
PROBABLE CAUSES
CURE
Notwithstanding the
machine is properly
operated, no dust delivery
occurs
The motor does not function
The fuse is burnt-out
Replace the fuse
The battery is exhausted or
down
Replace or recharge the
battery
The fan is jammed
Replace the fan
The electric cable is
disconnected
Replace or repair the
cable
The microswitch is not
working
Replace the
microswitch
The electric motor is out of
order
Replace the motor
The switch is not working
Replace the switch
The motor functions
The conduits are clogged
Clean the conduits
The measuring device is
clogged
Clean the measuring
device
The measuring device is
broken
Replace the measuring
device