Spring Loaded In-Counter Cup Dispenser Operator’s Manual
3
5. Lightly tighten one of the adjusting ring screws to hold the ring in
place.
TEST THE DISPENSER
1. Test the dispenser by pulling a cup from the tube.
2. Rotate the adjustment ring as necessary to achieve one-at-time cup
dispensing with minimum drag.
3. Fill the dispenser with a full stack of cups and retest the
performance. Adjust the ring as necessary.
4. Tighten the three adjusting ring screws. Do not over-tighten.
5. Re-attach the bezel to the dispenser. Note the bezel does not need to
be removed to refill cups.
CLEANING
NOTICE: Do not use abrasive materials, scratching cleansers or
scouring pad to clean the unit. These can damage the
finish.
Clean the dispenser on a regular basis.
1. Remove the bezel.
2. Remove all of the cups.
3. Push plate and spring down.
4. While holding down the plate, wipe the interior with a soft cloth
damp cloth.
5. Dry the interior with a soft cloth.
6. Reinstall the bezel.
CHANGE DEFAULT SPRING (OPTIONAL)
1. Pull off the retaining ring from the bottom the dispenser. Remove
the end cap.
NOTICE: Notice the cap is under pressure from the spring.
2. Remove the spring and insert the heavier weight spring.
3. Align the holes in the tube to those in the end cap. Reinstall the end
cap and retaining ring.
Adjusting
ring screw
Adjusting
ring screw
Adjusting ring screw
