41.VW.2210.3102_BA_V00_EN
VAS 681 003A
29
EN | Operation
While the self-test is ongoing, you can already control certain functions using the function
keys (see the “Using the LC display” section).
If malfunctions are detected during the self-test, they are indicated on the LC display (see the
“Troubleshooting” section).
At the end of a successful self-test, the messages “
Connect vehicle
” and “
Ready
” appear
on the LC display in alternation.
You can now begin the charging process.
Starting charging
Setting the charging time
Before beginning charging, you can set the maximum charging time on the LC display.
Requirement:
•
The DC charger must be switched on (see the “Cold start” and “Warm start” chapters).
•
Charging must not be active.
In the main menu, open the “
Configuration parameters
” submenu by pressing function
key F1.
Navigate to the “
Charging time
” parameter by pressing function keys F2 (down) and F3
(up).
Select the “
Charging time
” parameter to edit by pressing function key F4 (select).
If the preset value is correct, exit this setting by pressing function key F1 (cancel).
Change the charging time by pressing function keys F2 (down) and F3 (up) within the
limits 0:01 and 24:00 (hh:mm format).
Confirm the set value by pressing function key F4 (confirm).
Exit the parameter menu by pressing function key F1 (exit).
You have successfully set the charging time for the DC charger.
Charging time
Charging time
Charging time
6:00
0:01
24:00
6:00
