Volkswagen Transporter 2016, Workshop Manual

Page: 43 / 73

7.2 Removing and installing auxiliary air
heater Airtronic D3
Note
A type plate is fitted on the auxiliary air heater unit. This plate
provides information about the type of auxiliary air heater installed
in the vehicle ⇒ page 41 .
Note
The auxiliary air heater Airtronic D3 with bracket should only be
removed if the bracket is damaged.
Removing without bracket ⇒ page 41
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1410-
Removing
– Separate electrical 10-pin connector - T10ba- -1- from auxili‐
ary air heater beneath front right seat.
– Remove right underbody cladding ⇒ General body repairs,
exterior; Rep. gr. 66 ; Underbody cladding; Assembly over‐
view - underbody cladding .
– Guide wiring harnesses through opening in floor.
CAUTION
The fuel system is pressurised.
Danger of injury caused by fuel spray.
– Wear protective goggles.
– Wear protective gloves.
– To release pressure, wrap a clean cloth around the connec‐
tion and carefully loosen the connection.
– Separate fuel line -arrow- from auxiliary air heater.
Transporter 2016 ➤
Auxiliary heater - Edition 04.2020
7. Auxiliary air heater
39