safety button so that they cannot be
opened or closed.
NOTICE
During sudden rain showers, water can enter
the vehicle interior via open windows and
cause damage to the vehicle. Correct opera-
tion of the controls also cannot be guaran-
teed.
One-touch opening and closing and
the roll-back function will not work if
there is a fault in the electric windows. Go to
a qualified workshop.
Convenience opening and closing
works only when one-touch opening
and closing is activated for all electric win-
dows.
Electric window roll-back
function
The roll-back function for the electric win-
dows can reduce the risk of injuries when the
windows are closing.
If the window is not able to close because it
is stiff or because of an obstruction, the win-
dow will immediately open again → .
— Check to see why the window has not
closed.
— Try to close the window again.
— If the window closing process is interrup-
ted again, the roll-back function will be
disabled for a few seconds.
— If the window still cannot be closed, the
window stops where it is. To close the
window without the roll-back function,
press the button again within a few sec-
onds → .
Closing windows without roll-back function
— Attempt to close the window again within
a few seconds by holding the button. The
roll-back function is deactivated in the
process.
— If the closing procedure takes longer than
several seconds, the roll-back function will
be reactivated. If it is still stiff or obstruc-
ted, the window will stop and open again
automatically.
— Please go to a qualified workshop if the
window still cannot be closed.
WARNING
Closing the electric windows without the
roll-back function can lead to severe inju-
ries.
·
Always close the window carefully.
·
Ensure that nobody obstructs the path
of the window, especially if a window is
being closed when the roll-back function
is not active.
·
The roll-back function does not prevent
fingers or other body parts from being
pressed against the window frame and
sustaining injury.
The roll-back function is also activated
if the convenience closing function on
the vehicle key is used to close the windows.
Troubleshooting
One-touch opening and closing does not
work
One-touch opening and closing is deactivated
if the 12-volt vehicle battery has been dis-
connected or discharged while the windows
were not fully closed. The function will have
to be reset.
— Switch on the ignition.
— Close all windows and doors.
— Pull up the button for the window and
hold it in this position for a few seconds.
— Let go of the button, then pull it up again
and hold it in this position. One-touch
opening and closing is now ready for oper-
ation.
Windows
91
11A012720AB
