7
8. After installing the housing to the hanging board, use cross screwdriver or straight screwdriver
to adjust the screw of the angle iron bracket, direct the housing level position and height till it is
suitable. Adjust method: Adjust rang of the angle iron
Bracket is 0-25mm, clockwise twist the screw of the 4 angle iron bracket, slightly move the
housing upwards; meanwhile, anticlockwise twist the screw of the angle iron bracket, slightly move
the housing downwards. Use the cross screwdriver to screw the safety screw tightly after the level
position and height is suitable.(Refer to Pic 14)
HINTS FOR EXHAUST DUCT INSTALLATION
The following rules must be strictly followed to obtain optimal air extraction:
• Keep expansion pipe short and straight.
• Do not reduce the size or restrict expansion pipe.
• When using expansion pipe always install the pipe pulled taut to minimize pressure loss.
• Failure to observe these basic instructions will reduce the performance and increase noise levels
of the cooker hood.
• Any installation work must be carried out by a qualified electrician or competent person.
• Do not connect the ducting system of the hood to any existing ventilation system which is being
used for any other appliance ,such as warmer tube, gas tube , hot wind tube.
• The angle of the bend of the expansion pipe should not be less than 120º; you must direct the
pipe horizontally, or, alternatively, the pipe should go up from the initial point and should be led to
an outer wall.
• After the installation ,make sure that the cooker hood is level to avoid grease collection at on end.
• Ensure the expansion pipe selected for installation complies with relevant standards and is
fire retardant.
WARNING
• For safety reason, please use only the same size of
fixing or mounting screw which are recommended in
this instruction manual.
• Failure to install the screws or fixing device in
accordance with these instructions may result in
electrical hazards.