Vmetro M5210RP-EFF, User Manual, Page: 30 / 130

16
M5000 Series: User Guide Issued June 20, 2007
Installation and Hardware description
PCI to RACEway Bridge
The PCI to RACEway bridge is configured using switch SW7.
Processor Subsystem
The Processor Subsystem is configured using the switch SW10.
PMC Monarch Selection
The PMC Monarch Selection is done using the switch SW6.
TABLE 2-6.
RACEway-to-PCI bridge SW7 settings
Switch Function
1 Operating Mode
The bridge is configured in bridge mode/endpoint mode when the switch is ON/OFF.
This switch is connected to the pin RES_PROM_P on the bridge.
Leave open.
2 Serial EEPROM Autoload
ON enables the Serial EEPROM Autoload process.
TABLE 2-7.
Processor Subsystem SW10
Switch Function
1 Processor MFS Serial EEPROM Write Enable
ON to write-enable the Processor MFS Serial EEPROM.
2 Processor Boot Serial EEPROM Write Enable
ON enables write operations to the Processor Boot Serial EEPROM devices.
3 Processor Flash Write Enable
OFF enables write operations to the Processor Flash.
4 Processor Flash Monitor Write Enable
ON enables write operations to the Monitor area of the Processor Flash
5 Processor Boot
ON/OFF to boot the processor from Flash/PCI.
6 Fibre Channel Flash Write Enable
ON enables write operations to the Fibre Channel Flash devices.
TABLE 2-8.
PMC Monarch Selection SW6 settings
Switch Function
1 PMC#1 MONARCH Setup
ON to setup the PMC#1 as MONARCH.