VMAC
–
Vehicle Mounted Air Compressors
Toll Free:
1-888-241-2289
Fax: 1-250-740-3201
22
4.1 Installing the Control Box and Throttle
Control
□
Remove the plastic trim panel from the doorsill and the kick
panel on the driv
er’s side.
□
Mount the control box on the floor beside the driver’s seat. Use
the bracket as a template, drill three 3/32 inch holes through the
cab floor and fasten the bracket to the floor of the cab using
three #8 pan head screws. Fasten the control box onto the
bracket using the four screws, washers and nuts.
□
Route the cables from the control box along the doorsill, under
the trim panel, behind the kick panel and up under the dash.
Replace the doorsill trim and the kick panel.
□
Mount the throttle control under the dash to the right of the
steering column so that the connectors will easily reach the
accelerator pedal. Secure it in place with ties.
Keep wires away from the park brake mechanism.
Route wires clear of the steering column and pedals so
they do not contact moving parts. Before drilling holes,
make sure that there are no OEM wire bundles where
you will be drilling.
4.2 Connecting the Wiring
□
Unplug the cable from the foot pedal assembly and connect it to
the throttle control box. Connect the throttle control box cable to
the foot pedal assembly.
NOTE: The connector from the throttle box does not
have a positive mechanical lock to keep the connectors
together. If this connection comes apart it will cause
drivability problems. Secure the connection using a
small nylon tie strap.
□
Connect the interface harness to the matching connector from
the control box.
!
