33
11.
M
AINTENANCE
Security measures
Before starting maintenance work, make sure
that the boiler is disconnected from the
electricity supply, that the boiler is cold and the
ashes are extinguished.
Turn off the main power switch located on the
rear panel, right side, and the corresponding
cable.
Use suitable cleaning equipment.
It is recommended to use a vacuum cleaner
suitable for ash.
Boiler Cleaning Function
Your boiler has a function called “Cleaning”
which is intended to facilitate the cleaning
operation of the same, thus avoiding the
dispersion of ash that is thus sucked up by the
chimney.
The "Cleaning" function within the "Settings"
menu is displayed in the menu only if the boiler
is OFF. It allows the smoke extraction motor, at
maximum speed, to clean the exchanger and the
brazier.
Pressing “Set” the
panel displays a screen with
the message “Enabled” and pressing ESC returns
to the previous menu.
Press “OK” to activate and “ESC” to stop.
Maintenance to be carried
out by the user
11.3.1. Daily cleaning
Due to the accumulation of ash in the brazier in
your equipment, which may cause failure to light
or lack of performance, it is necessary to clean it
daily.
Carefully clean the brazier, ensuring that all
holes are clear.
It is natural for “stone” to form at the base of
the brazier, this phenomenon largely depends on
the quality of the pellets used.
Figure 11- Brazier
Put the brazier back in place ensuring the
perfect alignment of the resistance hole with the
respective resistance. Incorrect alignment can
cause ignition failure.
11.3.2. Weekly cleaning
Glass cleaning
Wait for the glass to be completely cold,
otherwise it will break. The weekly cleaning of
the glass should be done with a damp cloth or
paper mixed with a little ash rubbing until it is
clean. You can use special products or foams for
neoceramic glass by placing it directly on a cloth
or paper, but never projecting it directly onto
the glass.
IMPORTANT, do not let the product run down to
the metal parts as it will cause corrosion and
quickly deteriorate your boiler.
Ash cleaning
The cleaning of the compartment that houses
the ash box must be carried out from week to
week or when necessary.
To clean it, it is necessary to remove the ash
box using the process explained below.
The compartment must be cleaned using an ash
vacuum.
Open the combustion chamber door, remove the
brazier and vacuum the ash using an ash
vacuum.
