3
1.
G
ENERAL CONSIDERATIONS
TEK Biomasse
®
is a registered trademark,
whose
air
conditioning
equipment
is
manufactured by Vitor Monteiro Lda. and
tested in accordance with European reference
safety standards.
Symbology
The following graphic symbols are used in this
manual:
- Tips and useful information,
- Danger, important information to avoid
accidents.
Attention:
the symbols indicate important
information in order to make the manual more
lucid. However, this does not relieve the user
of the obligation to comply with requirements
that are not marked with a graphic symbol.
This manual is divided into two parts: one for
the user and one for the installer. Both parts
contain important and significant information
for safety issues, therefore, the user should
read both parts of the manual. We are not
responsible for any damage caused by failure
to follow these instructions.
Use
This equipment is a boiler intended for
domestic heating and is reserved for indoor
installation in a technical area. It must not be
operated by anyone unfamiliar with this
manual as well as by children, the elderly and
others whose physical, mental and intellectual
capacities are impaired.
Failure to observe these rules can cause
property damage, threat to human life and
health and domestic animals.
Packaging
of
documentation
This manual, as well as any other applicable
documentation, must be stored diligently so
that it is available at all times. In case of
moving or selling the equipment, the
documentation
must
be
attached
and
forwarded to the new user/owner.
2.
S
ECURITY WARNINGS
The instructions contained in this manual must
be followed, both by the Technician (Installer,
Maintenance) and by the User. Some of the
warnings, if not followed, void the warranty
contract.
Installer Technician and
Maintenance Manager
The installation of the boiler is reserved
exclusively for specialized technicians.
The responsibility for installing the equipment
cannot be considered the responsibility of Vitor
Monteiro, Lda.
In case of necessity of works in the place
where the boiler is installed, these are the
responsibility of the user and whose expenses
falls on him. The works, before being carried
out, must be approved by the user.
The technical responsibility for the installation
rests with the installer, who is asked to carry
out the chimney and air intake checks and
carry out the proposed installation solutions
correctly.
Installation of the equipment must comply with
all
national
and
European
regulations,
standards and laws.
The equipment must be installed on a surface
capable of supporting its weight.
Confirm that the chimney design and air intake
are in accordance with the installed equipment.
Do not make electrical connections with
temporary or non-insulated cables.
Check that the equipment ground connection is
effective.
Before starting the unpacking and assembling
or disassembling of the boiler, the Technician
must take the safety measures prescribed by
law, with special attention to those mentioned
below:
