TRudder pedals. Installation and setup manual
14
If when the pedal is in extreme position but marker is not on range limit, it is
recommended to increase the support shaft height (see“Support shaft height setup”
on page 11). If it is impossible, set
Mpl
value equal to 10.
4.
Axis parameters setup
Set deadzones of the pedal axis using
DzLo
field (deadzone in the center) and
DzHi
field (deadzones on range limits).
Use
Df
option in the
Common
group to control the dynamic filtering of axis
response. Set degree of filtration in
Filter
field and its treshold in
Trh
field.
Set number of digits for the axis in the
Precis
field on the
Logical Axes
tab
(fig. 4.2). Recommended value for digital sensor MARS is 10.
You can choose name of the axis from
HID Usage
combobox. It is needed, for
example, If some connected devises have axis with the same names. Be carefully
changing this parameters! In some cases the renamed axis will not work. If it
happens restore initial axis name.
4.2.
5.
Response curves
Use the controls on the
Response curve
tab to set up response curve of the axis.
Execute the following operations.
1. Select the string with number, corresponding to the calibtrated axis. For TRudder
pedals it is the first axis.
2. Move sliders to shape response curve. The values in the fields will correspond to
sliders positions.
Linked
option enables to link sliders positions. If the option is checked, when you
move one slider, the adjasent ones will move too. Set the degree of dependence
between sliders using
QFactor
slider.
3. If you want to apply custom shaped response curve to the axis, check
Eq
option on
Physical Axis
tab for it.
Fig. 4.2.
