User Manual rev. 1.2. Aug. 2015
198
4-3.3 QCL Status
The section will let you know how to configure and shows the QCL status
by different QCL users. Each row describes the QCE that is defined. It is a conflict if a specific
QCE is not applied to the hardware due to hardware limitations. The maximum number of
QCEs is 256 on each switch.
Web Interface
To display the QoS Control List Status in the web interface:
1. Click Monitor, Ports, then QCL Status
2. If you want to auto-
refresh the information then you need to evoke the “Auto-refresh”.
3. Scroll to select the combined, static, Voice VLAN and conflict.
4.
To Click the “Refresh“ to refresh an entry of the MVR Statistics Information.
Figure 4-
3
.3: The QoS Control List Status
Parameter description:
User :
Indicates the QCL user.
QCE#
Indicates the index of QCE.
Frame Type :
Indicates the type of frame to look for incoming frames. Possible frame types are:
Any: The QCE will match all frame type.
Ethernet: Only Ethernet frames (with Ether Type 0x600-0xFFFF) are allowed.
LLC: Only (LLC) frames are allowed
LLC: Only (SNAP) frames are allowed.
IPv4: The QCE will match only IPV4 frames.
IPv6: The QCE will match only IPV6 frames.
Port :
Indicates the list of ports configured with the QCE.
Action :
Indicates the classification action taken on ingress frame if parameters configured are
matched with the frame's content.
There are three action fields: Class, DPL and DSCP.
Class: Classified QoS Class; if a frame matches the QCE it will be put in the queue.
Summary of Contents for AW-GEV-264A Series
