4x2 HDMI 2.0 Seamless Matrix Switcher
13
5. Button Control
5.1 Manual Switching
When the switcher is in manual switching mode, the AUTO button LED goes out.
Please follow the below steps to switch input source to output channel.
1) Press any one of four input buttons to select input source, and the corresponding
button LED turns blue.
2) Press either
1.HDMI
or
2.HDBT
output button to select output channel, and the
corresponding button LED turns blue.
3) Press the input button again to confirm switching setting, otherwise, it will
automatically confirm after three seconds.
5.2 Auto Switching
Please follow the below steps to enable auto switching mode for
1.HDMI
or
2.HDBT
output.
1) Press
AUTO
, and the button LED turns blue.
2) Press either
1.HDMI
or
2.HDBT
output button, and the corresponding button LED
turns blue.
3) Press
AUTO
button again to confirm the setting, otherwise, it will automatically
confirm after three seconds.
4) Repeat the above three steps can exit auto mode, but the input source will remain
the current setting.
Note:
The AUTO button LED illuminates blue when the
1.HDMI
output is in auto mode
or the
2.HDBT
output in auto mode.
When in auto mode, the switcher will switch according to the following rules:
The switcher will switch to the first available active input starting at input 1 to 4.
New input: The switcher will automatically select the new input once detecting a
new input.
Reboot: If power is restored to the switcher, it will automatically reconnect the input
before powered off.
Source removed: When an active source is removed, the switcher will switch to the
first available active input starting at
1.HDMI
input.
In auto mode, the input source also can be switched by the manual switching
steps.