DU8395Z Series DLP Projector - User Manual
UM83950922EN01
54
Note
•
Estimate Altitude is calculated by atmosphere pressure, it may have the tolerance comparing to actual altitude.
•
If any over temperature or system protection message, please adjust High Altitude by Manual.
•
In some application, regular cooling fan setting may not supply enough cold air for system cooling even the
projector is installed in an area under 5000 feet. In this case, please set High Altitude to On.
Auto Power Off
This function is set to OFF by default. When it is set to ON and no input signal is received within 20 minutes, the pro-
jector will turn off automatically.
Auto Power On
This function is set to OFF by default. When it is set to ON, the projector will turn on automatically when y AC power
is turned on next time ( press the power switch on the projector to turn it on automatically, instead of using the remote
control or the machine keypad button ). Set this function to OFF if it’s unnecessary.
Network
Use this function to configurator the network settings so that you can control the projector via the network.
Press ▲▼ and Enter button to select Network and network settings. Please refer to Remote Communication Manual
for further information.
Network Mode
Projector control
: Display the IP address of projector. You can input the correct IP address
to control the projector via the internet.
Service :
If you want to upgrade the software of projector. Use this function to query the
Service's ip address. Then enter the correct Service IP address to upgrade the projector's
software via the internet.
Standby Power
This option allows you to set up power consumption at standby status,
On
: Projector maintains in the standby at higher power consumption (< 6W) for projector
control via LAN. In this mode, the projector can be turned on by RS-232 command or web
control.
Off :
Projector maintains in the standby at lowest power consumption (<0.5W), the projector
can be turned on by the power button on the remote control or control panel only.
DHCP
Set DHCP to ON/OFF. When DHCP is set to ON, the DHCP server of the domain will assign
an IP address to the projector. The IP address will appear on the IP address window without
need to make any input. If the domain cannot assign any IP address, 0.0.0.0 will be shown
on the IP address window.
IP Address
To specify an IP address, press the Enter button to show the IP address input window. Use
the ◄► button to select the number in the address to change. Use the ▲▼ button to in
-
crease or decrease the number in the IP address. Network IP Address 172. xxx. xxx. xxx.
Subnet Mask
Set the subnet mask. The input method is the same as the setting for IP address.
Gateway
Set the gateway. The input method is the same as the setting for IP address.
DNS
Set the DNS. The input method is the same as the setting for IP address.
MAC Address
Show projector’s MAC Address.
Summary of Contents for DU8395Z
Page 1: ...DU8395Z User s Manual ...
