DU8195Z Series DLP Projector - User Manual
UM81950823EN02
55
Light Power
Use ◄ ►button to select the power save mode (Eco), normal (Normal) or custom power level.
Light Power
ECO :
Projection operates in the energy-saving mode, which is equivalent to 80 %
power of light source.
Normal :
Projection operating with normal light power can obtain the brightest pro-
jection display.
Custom :
User can decide the power level depending on his or her preference.
Custom Power Level
Use the ◄► function to select the Custom Power Level. This function is available
only when the Light Power is set to
Custom
,which allow to adjust the "Normal"
mode range from 20% to 100%, and it cannot be selected under the Normal or Eco
mode., and it cannot be selected under the Normal or Eco mode.
Constant Brightness
If select On, when the laser luminance decrease by duration of usage. The projector
will add the power level automatically for getting the constant brightness. However,
if power level is set to the highest brightness, this function will not achieve significant
improvement.
Background
User can use this function to specify the image displayed on the blank screen when there is no input signal. The se-
lectable items are Logo, Black and Blue, the default setting is Logo.
Startup Logo
Press ENTER button, and use the ◄► function to turn on / off the Startup Logo.
Infrared Remote
Remote Sensor
The default is On. However, there are three conditions that will be suggested to turn off
“Remote Sensor”; the possible condition is that if the user uses wired remote control,
he can set this function to Off, or that if the projector IR location is exposed to the bright
sunlight or fluorescence, or that projector control is not controlled by remote. If the user
would like to reset to On, user can only set by OSD panel or RS-232.
ID Control Enable
This option allows you to enable the projector ID control function. You can turn on this
function and give an ID number for the projector, then set the same ID number for the re-
mote control to match the projector ID. After ID code is set, you can control the specified
projector by the remote control.
Control ID Number
Select the option then press ◄ or ► to set the ID number of the projector, this option is
selectable when Projector ID Control is enabled.
Summary of Contents for DU8195Z
Page 1: ...DU8195Z User s Manual ...
