Vivitek DU72x Series, User Manual

Page: 58 / 98

DLP Projector—User’s Manual
–
45
–
Advanced 1 Feature
Press the Menu button to open the OSD
menu. Press ◄► to move to the
Settings 2
menu. Press ▲▼ to
move to the Advanced 1 menu and then press Enter
or ►. Press ▲▼ to move up and down in the
Advanced 1
menu. Press ◄► to enter and change values for setting.
I
TEM
D
ESCRIPTION
Menu Position Press the cursor
◄► button to enter and select different OSD location
Translucent Menu Press the cursor
◄► button to enter and select OSD background translucent level
Low Power Mode Press the cursor
◄► button to enter and turn Low Power Mode On or On By Lan
Fan Speed
Press the cursor ◄► button to enter and toggle between Normal and High fan
speeds.
Note : We recommend selecting high speed in high temperatures, high humidity, or
high altitude (higher than 1500m/4921ft) areas
Light Info
Press
(Enter) / ► to enter the Light Info menu to display the light hours for each
light mode
Projector ID
Press the cursor
◄► button to enter and adjust a two digit projector ID from 00
through 98
Remote ID
Press the cursor ◄► buttons to select remote ID to fit the current remote ID settings
Network
Press
(Enter) / ► to enter the Network menu. See page
46 for more information on
Network
HDBaseT-
IR/RS232 Press
(Enter) / ► to enter the HDBaseT Setting menu. See page
57 for more
information on HDBaseT-IR/RS232
Note:
About “On By Lan”, RJ45 will support to be waked up in this mode(Under 3W) but scalar won’t.
Note:
1. Remoter with Default customer code will be available for any Remote ID setting on the OSD.
2. Status key will be available for any Remote ID setting on the OSD
3. IF users forget the current Remote ID setting, please press the Status key to call out the
INFORMATION OSD to check the current Remote ID setting and then adjust the ID on the remoter
to meet the OSD setting.
4. After adjusting Remote ID from OSD, only if the OSD Menu has been closed then the new ID value
can be taken effected and memorized.
5.
The setting value “Default” means ID 0 on the remoter.