DK10000Z Series DLP Projector - User Manual
UM100000823EN03
20
Selecting the Input Voltage of AC Power
There is one slide switch near AC switch, pleases switch it to corresponding input voltage of AC power.
Please switch it to 115V if the input voltage range is 100V to 130V,
switch to 230V if input voltage range is 200V to 240V.
VOLTAGE SELECT
˅ᙟヅࣱⴆႹ
200~240 VAC
100~130 VAC
230
200-240 V~
100-130 V~
AC 100-130V
200-240 V~
100-130 V~
AC 200-240V
Important !
When the input voltage is 110V, the current supplied by the power
supply does not provide the current required to run the projector at
full power. In this case, the projector will automatically reduce the light
source power to 65%, and the projector light output will also be reduced
to about 65% of the nominal brightness accordingly to ensure that the
projector can operate normally
Connecting to AC Power Supply
The AC power cord is included in the box; plug the power cord to the AC socket on the IO panel.
Turning on the Projector
Once the projector is correctly located and the power cable and other connections are in place, it is important that the
projector is correctly powered on in order to avoid damage to components and un-necessary wear and tear. Refer to
the following guide to power on the projector.
1. Press the main power switch to the on ( I ) position as
shown. POWER LEDs flashes then lights red.
PO
WE
R
STAT
US
LIGH
T
TEMP
.
VOLTAGE SELECT
Ҭࢬႝᓸᒧ
200~240 VAC
100~130 VAC
230
O
I
2. Press the POWER button on the control panel or ON
button on the remote control.
MENU
EXIT
POWER INPUT
AUTO
SYNC ASPECT
