Vivax DD-207 WH, User Manual

Page: 29 / 48

9
◆
For the first time you install your refrigerator, set the thermostat knob at “Med”.
Give your refrigerator time to cool down completely before adding food. It is the best to wait
24 hours before adding food. The thermostat knob controls the temperature. When the
thermostat control knob is set to OFF, the refrigerator will not be running.
4.2 Noise Inside the Unit!
You may notice that your unit makes some unusual noises. Most of these are perfectly normal,
but you should be aware of them!
These noises are caused by the circulation of the refrigerant liquid in the cooling system. It has
become more pronounced since the introduction of CFC free gases. This is not a fault and will not
affect the performance of your unit. This is the compressor motor working, as it pumps the
refrigerant around the system.
4.3 Tips for Keeping Food in the Unit
◆
Cooked meats/fishes should always be stored on a shelf above raw meats/fishes to avoid
bacterial transfer. Keep raw meats/fishes in a container which is large enough to collect juices
and cover it properly. Place the container on the lowest shelf.
◆
Leave space around your food, to allow air to circulate inside the unit. Ensure all parts of the
unit are kept cool.
◆
To prevent transfer of favours and drying out, pack or cover the food separately. Fruit and
vegetables do not need to be wrapped.
◆
Always let pre-cooked food cool down before you put in the unit. This will help to maintain
the internal temperature of the unit.
◆
To prevent cold air escaping from the unit, try to limit the number of times you open the
door. We recommend that you only open the door when you need to put food in or take food
out.
4.4 Change the Light Bulb
Lamp replacement by professionals
5. CLEANING
5.1
Defrosting
Auto-defrost for Frost-free Refrigerator
5.2 Cleaning the Interior and the Exterior of the Unit
◆
Remove all the shelves and the salad bin. To remove the salad bin first remove the lower
door shelf.
◆
Wipe the inside of the unit with a weak solution of bicarbonate soda and then rinse with
warm water using a
“
wrung-out
”
sponge or cloth. Wipe completely dry before replacing the
shelves and salad bin.
◆
Use a damp cloth to clean the exterior, and then wipe with a standard furniture polish. Make
sure that the door is closed to avoid the polish getting on the magnetic door seal or inside
the unit.
◆
The grille of the condenser at the back of the unit and the adjacent components can be
vacuumed using a soft brush attachment.