VIVAX home AJ-700, User Manual, Page: 7 / 60

AJ-700
3. Allow the juicer to run for one minute before turning ‘Off’ to allow any excess
juice to be extract from the pulp.
4. A plastic bag can be put in the pulp container for easy clean-up.
5. Disassemble the Juicer and rinse off the pulp immediately after juicing. The
Strainer Basket/Cutting Blades can be soaked in water to loosen the pulp.
Then wash in warm soapy water.
6. Wash parts immediately after use to avoid discolouration of the plastic parts
which may occur with some fruits and vegetables.
7. If juicing herbs or leafy green vegetables process in combination with other
fruits or vegetables to yield more juice.
CARE AND CLEANING
How to disassemble the Juicer
IMPORTANT
: Before disassembling the Juicer make sure that the Electronic
Control is in the Off position, the plug has been removed from the wall outlet and
the motor has stopped completely.
1.
Remove the Food Pusher from the Feed Tube.
2. Remove the Pulp Container by holding onto
the Feed Tube and tilting the juicer slightly
disengage the Pulp Container.
3. Remove the Juice Jug.
4. Hold the Pulp Chute/Juicer Cover and disengage
The Locking Bar from the grooves on the side of
The Pulp Chute/Juicer Cover.
5. Lift and remove the Pulp Chute/Juicer Cover.
6. Remove the Plastic Juice Collector and Strainer
Basket by placing one hand under the spout and the
other under the black plastic edge opposite the spout
and lifting upwards. The Stainless Steel Strainer Basket
can be removed from the Juice Collector by pushing it up
through the hole in the bottom of the Juice Collector.
NOTE: Be careful when handling the Strainer Basket as the as the cutting
blades are very sharp.
How to Clean
1. Move the Control Switch to the Off position and wait for